Can molybdenum pipe achieve a 180° U-shaped bend ?

Nov 13, 2026

Leave a message

Can high-purity molybdenum tubes achieve a 180° U-shaped bend?

 


In our manufacturing process, it is possible, but cold bending processing must not be carried out; because the room-temperature brittleness of molybdenum materials is extremely strong. If cold bending is performed, cracking will occur. Therefore, the only stable and mature method in our current production process is through core shaft induction hot bending (induction heating and hot bending); however, if the bending radius is very small and the process is very difficult, our alternative solution is to connect and weld two 90° molybdenum tubes for U-shaped splicing.

 

Main process is as follows, which is also the preferred solution we usually recommend to our customers, that is, through local induction heating + core shaft hot bending .The process is induction hot bending (core shaft hot bending, one-piece 180° U bend)


1. Insert a high-temperature resistant ceramic or graphite core shaft inside the molybdenum tube to prevent wrinkling on the inner side and collapse of the tube wall 


2. Use a medium-frequency induction coil to only heat the bending area, with the heating range maintaining a stable temperature between 900~1200°C (the molybdenum recrystallization temperature range, plasticity improves; > 1300°C the oxidation rate sharply increases)


3. The entire heating process must ensure the use of argon gas protection (this is a very important detail because if molybdenum is not protected by argon gas and only reaches a temperature above 400°C, once it comes into contact with air, it will rapidly oxidize, resulting in the formation of MoO3 on the surface, surface flaking, cracking and breaking. Therefore, a local sealed argon atmosphere is required.

 

4. During the machining process of the CNC tube bending machine, it is also necessary to push the bending process at a uniform and slow speed, so as to achieve the drawing requirements and form a 180° U shape in one go. Here, it is particularly important to control the thinning rate during the processing, because during the bending processing of the molybdenum tube, the wall thickness at the bending part will be affected and prone to thinning, but usually, the outer tube wall thinning is controlled to be less than or equal to 10-15%.


5. After the molybdenum tube undergoes the bending treatment, the bent tube needs to be slowly cooled in the furnace, not rapidly cooled, and no wind cooling, water cooling, etc. are allowed. This is mainly to avoid cracks after thermal stress; after the molybdenum bent tube cools down, surface cleaning, surface treatment such as annealing and stress relief should be carried out.

 

The advantage of this process is that the bent pipe workpiece can be formed as a whole, without welds, with a smooth flow channel, suitable for vacuum / high-temperature piping, and can be used in high-temperature furnaces.

 

Note: If the bending radius R of the molybdenum bent pipe is too small, the production cost will be higher during the generation process, because the smaller R is, the higher the scrap rate is, resulting in a higher production cost.

 

How To Cooperate With Us?

Contact person :Tracy 

Our address

Baoji city ,shaanxi province, China 

Phone Number/ Whatsapp 

0086-18291730106

modular-1

 

 

Send Inquiry